ETS 16 Przewodnik Instalacji Pobierz pdf (Strona 49)

Troubleshooting

ETS Installation Guide 49

Problem/Message Error Remedy

A rapidly-blinking OK LED

may signal boot failure.

Reboot the unit. When the ETS is

running normally, the OK LED

blinks every two seconds.

The ETS is not connected

properly to the Ethernet.

Ensure that the ETS is firmly

connected to a functional and

properly-terminated network node.

The ETS Ethernet address

is invalid.

The ETS Ethernet address is

located on the bottom of the unit.

Use the Set Hardware command to

set the correct address, then

reboot. See Entering Commands at

the Boot Prompt on page 50.

The terminal shows a

Boot> prompt rather than

a Local> prompt.

Init Noboot command was

entered.

See Entering Commands at the

Boot Prompt on page 50.

If the OK LED blinks

rapidly, the Flash ROM

code may be corrupt.

The ETS passes power-

up diagnostics, but

attempts to download

new Flash ROM code

from a network host.

If you did not request a

TFTP boot, the flash ROM

code is corrupt. The unit

will remain in boot mode.

Reboot the unit. If you get the same

message, you will need to reload

Flash ROM. Refer to D:Updating

Software.

DHCP Troubleshooting

Table B-3. DHCP Troubleshooting

Area to Check Diagnosis/Remedy

DHCP is enabled on the

ETS

Use the Set Server DHCP Enabled

command. If you manually enter an IP

address, DHCP is automatically disabled.

Make sure the DHCP

server is operational.

Check to see that the DHCP server is on

and is functioning correctly.

The ETS gets its IP

address from the DHCP

server

Refer to the DHCP Manager on your DHCP

server for information about addresses in

use. If the DHCP server doesn’t list your

ETS IP address, there may be a problem.

BOOTP Troubleshooting

If the BOOTP request is failing and you have configured your host to respond to the

request, check these areas:

Table B-4. BOOTP Troubleshooting

Area to Check Explanation

BOOTP is in your system’s

/etc/services file

BOOTP must be an uncommented line in

/etc/services.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 67 68

Komentarze do niniejszej Instrukcji

Brak uwag

La liste des produits de Acoustic Energy contient 27 les manuels et guides d'utilisation des modèles 23 dans les appareils de type 12

Modèles	Type de document
Montrer tout acoustic-energy manuels en Récepteurs AV catégorie
Aego P5	Informations techniques Acoustic Energy Aego P5 Technical information, 8 pages

Modèles	Type de document
Montrer tout acoustic-energy manuels en Haut-parleurs catégorie
Aegis Evo Series	Manuel de l'utilisateur Acoustic Energy Aegis Evo Series User's Manual [en] , 5 pages
AELITE Three	Manuel de l'utilisateur Acoustic Energy AELITE Three User's Manual, 4 pages
AE32-165	Fiche technique Acoustic Energy Aegis 165Ci, 2 pages
Linear One	Manuel de l'utilisateur Acoustic Energy Linear One User's Manual, 8 pages
AE32-150	Fiche technique Acoustic Energy Aegis 150Ci, 2 pages

Modèles	Type de document
Montrer tout acoustic-energy manuels en Subwoofers catégorie
Aegis Evo Sub	Manuel de l'utilisateur Acoustic Energy AEGIS EVO 3, 3 pages

Modèles	Type de document
Montrer tout acoustic-energy manuels en Équipement musical supplémentaire catégorie
Combo Amplifiers	Manuel de l'utilisateur Acoustic Energy Combo Amplifiers User's Manual, 8 pages

ETS 16 Przewodnik Instalacji Strona 49

Komentarze do niniejszej Instrukcji

Acoustic Energy manuels